Signode PNSC-2 Pneumatic Push Type Combination Tool
The Signode PNSC-2 is a single reverse notch sealer used with regular duty or high tensile steel strapping, and recommended for use on round or irregular loads. Weighing 9.5 pounds, the tool uses its duck bill nose to push the seal, a feedwheel to pull tension, and jaws to notch the seal in a full combination action. The PNSC-2 applies up to 700 lbs. tension to steel strapping. The PNSC-2 is a relatively easy tool to operate thanks to the two bottom control system. The strap easily slides out after each strapping cycle. The PNSC-2 is very durable and reliable, composed of metal alloys, and can withstand exposure to various harsh conditions.
The PNSC-2 is available in three sizes:
PNSC 2-12: 1/2" (12.7mm) x 0.017-0.023" (0.43-0.58mm) Seal .5 Inch Push Seal
PNSC 2-58: 5/8" (15.9mm) x 0.017-0.023" (0.43-0.58mm) Seal .625 Inch Push Seal
PNSC 2-34: 3/4" (19.0mm) x 0.017-0.025" (0.43-0.64 34mm) Seal .75 Inch Push Seal
Signode PNSC-2 parts can now be easily ordered online through Allstrap! Click the "Order Parts" tab below, browse the PNSC-2 schematic to find the part you need, and add it to your cart!
How to Strap with the PNSC-2: While operating any strapping tool, safety precautions must be taken. Safety goggles and hand protection must be used and careful distance from the tool and the cargo must be maintained. First, thread the strap through the seal and wrap the strap around the load. Remove excess slack and pull opposite end back through the seal over top of the original strap. Hold the PNSC-2 in right hand and the strap in the other. Use the lever to lift the foot and slide the strapping in. Slide the tool forward as far as possible to ensure tight tensioning. Press the button to start tensioning. Once desired level is reached, the tool will automatically shut off. Press the sealing button to compete the sealing function until the tool automatically stops the sealing process. Cut the strap with the tool, then release.
Order Parts & Tool Repair
All parts for the PNSC-2, and the wear parts, can be ordered online in the "Order Parts Tab below. The PNSC-2 wearing parts include:
Worm Gear 422499
Side Plate Spacer 023028
The PNSC-2 is generally available rebuilt, please call for rebuilt pricing. Need your PNSC-2 Repaired? Send it to our tool repair department for a quick turnaround. Call Allstrap for an in-person demonstration. We keep Signode tools in stock, and have more experience with HD strapping than anyone in the country. There is a new battery powered sealer available! Signode's Grip Pack Sealer for steel strapping.
Strapping: For use with 1/2"-3/4" (16 mm-19 mm) x .017"-.025" (0.43 mm-0.64 mm) Apex Plus or Magnus strapping
Tension: 700 pounds, (1000 pounds special order).
Joint type: Single reverse notch
Weight: 9.5 lbs. (4.3 kg)
Part numbers: PNSC2-12: 422495 PNSC2-58: 422496 PNSC2-34: 422497
Allstrap Opinion: The PNSC-2 tool is very easy to use and light weight. However, with a single notch seal, 50% of the strength will be lost at the seal.